SPS 25A 1000V Glass Passivated Single Phase Bridge Rectifier Through Hole GBJ2510

Special Sun A·H·M Technology(Shanghai)Co.,Ltd.

SPS - ISO Factory for SMD and Through-hole Diodes and Rectifiers Since 2000


GBJ25005, GBJ2501, GBJ2502, GBJ2504, GBJ2506, GBJ2508, GBJ2510

Glass Passivated Die Construction

High Case Dielectric Strength of 2500VRMS

Low Reverse Leakage Current

Surge Overload Rating to 350A Peak

Ideal for Printed Circuit Board Applications

UL Listed Under Recognized Component Index

Lead Free Finish; RoHS Compliant 

Case: GBJ

Case Material: Molded Plastic. UL Flammability Classification 94V-0

Moisture Sensitivity: Level 1 per J-STD-020

Terminals: Plated Leads, Solderable per MIL-STD-202, Method 208

Lead Free Plating (Tin Finish).

Polarity: Molded on Body

Mounting: Through Hole for #6 Screw

Mounting Torque: 5.0 in-lbs Maximum

Weight: 6.6 grams (Approximate)

GBJ bridge rectifier needs special attention in installation and work, because the correct installation and correct use of GBJ bridge rectifier determine the service life of GBJ bridge rectifier.

The distance between the lower edge of the GBJ bridge rectifier and the surface of the commutator or collector ring should be kept within 2-4 mm. If the distance is too small, GBJ will easily scratch the commutator or bridge; if it is too large. The GBJ bridge rectifier is easy to move and cause damage. Ensure that the GBJ bridge rectifier works within the surface of the commutator or GBJ, and not close to the edge of the GBJ. If the GBJ bridge rectifier is improperly installed in the cold state, the GBJ bridge rectifier may not completely touch the surface of the collector ring after the GBJ shaft expands in the hot state. Grind the arc surface of the GBJ bridge rectifier to make it basically consistent with the GBJ sub or bridge rectifier.

Due to the gap between the GBJ and the bridge rectifier, and due to the slight deformation of the fixed parts of the GBJ bridge rectifier under the action of stress, the radius of curvature of the GBJ bridge rectifier section will be slightly larger than that of the commutator or the GBJ bridge rectifier. During the operation of the bridge rectifier, not all the cross-sectional area of the GBJ bridge rectifier is in contact with the commutator or the collector ring, but only a part of the area. Therefore, the arc surface of the GBJ bridge rectifier must be ground to make it basically consistent with the commutator or GBJ bridge rectifier ring.


Contact:Mr. Jerry Xu

Email: jerry@sps-elec.com

Website: https://www.spssemi.com/ 

Add:10F, Flat34, Caohejing Hi-tech park, No.258 Xinzhuan Road, Songjiang District, Shanghai

Check the best offer with SPS, a professional factory of diode rectifiers, bridge rectifiers, transistors etc.